Installation Instructions for existing DataPlus Professional DOS and CE users who want to update their older versions of DataPlus Professional DOS and CE to the most current DOS and CE version available.
This DataPlus Professional patch is ONLY for version 2.0 and later. It will NOT patch any package version prior to v2.0.
Only the following installations qualify:
A) DataPlus Professional 2.0 or greater.
B) DataPlus CE Host Upgrade v1.0 or greater. (CE Upgrade)
It will update all installed DataPlus Professional files if they qualify. The same patch is used for all registered DataPlus components including CE Host and the hand held Files. New Windows CE devices and platforms are now supported, check the compatibility list below.
Windows CE-based Hand Held Compatibility
The minimum requirements are as follows:
- An 80486, StrongARM-compatible, MIPS, or XScale processor
- Screen dimension of at least 320x240 or 240x320
- Windows CE v3.x, Windows CE.NET 4.x, Windows Mobile 2003, 2003 Second Edition or Windows Mobile 5
- 32MB of RAM
- 1MB of free storage space
DataPlus CE has been tested on the following Windows CE hand helds:
- Juniper Systems Archer
- Juniper Systems Allegro DOS/CE, CE and CX
- In-Situ Rugged Reader
- Trimble Ranger and Recon
- Trimble GeoExplorer CE
- Trimble Juno ST
- TDS Ranger and Recon
- Dell Axim
- Itronix FEX-21
- DAP Microflex 5320
- DAP Microflex 8640
To install the Patch...
If any DataPlus Professional components are running (i.e. Host etc.), close them first. Download the "DPP Patch Post 200.exe" file into an empty directory or Open (Run) it from its current location.
If saved to a local directory, from inside Windows Explorer double click on "DPP Patch Post 200.exe".
This will replace older files. Follow the instructions from the setup wizard.
| 
